Pinout for the gripper cable for Scorbot Controller-A - Electronics Forums

Author Topic: Pinout for the gripper cable for Scorbot Controller-A  (Read 5565 times)

ElectroNick

  • The forum moderator
  • Administrator
  • Full Member
  • *****
  • Posts: 154
  • Karma: +3/-0
  • The soldering iron is ON!
    • View Profile
    • Electronics Blog
Pinout for the gripper cable for Scorbot Controller-A
« on: January 06, 2012, 10:59:41 PM »
Hi all, looking for the pinout of that little DB9-DB9 cable that gets installed between a motor control card in the Controller-A and its 50-pin breakout board. For some mysterious reasons all other robot's axis are internally connected to that 50-pin connector which you plug your Scorbot V+ robot into but the gripper requires an additional external cable.
I have the Controller and the robot, all axis work except the gripper and I don't want to just guess the pinout, so your help in the matter will be greatly appreciated!
Thanks!

Electronics Forums

Pinout for the gripper cable for Scorbot Controller-A
« on: January 06, 2012, 10:59:41 PM »

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
6355 Views
Last post October 10, 2011, 01:17:34 AM
by kellydouglas
3 Replies
5206 Views
Last post November 19, 2011, 01:01:08 AM
by ElectroNick
1 Replies
14558 Views
Last post February 11, 2013, 12:15:21 PM
by ElectroNick
47 Replies
42020 Views
Last post March 31, 2016, 09:39:05 PM
by ElectroNick