Resources - Electronics Blog

Resources

Links to various files, tools and other useful resources at Elabz.com

Tools

Coming soon ...

Recent Comments
  • admin: Thanks! Glad you made it work! This way of driving a bipolar stepper was just to prove a point that it’s...
  • Matt: Hey bud I got this all to work after some trial and error, now how ever I would like to drive 2 steppers for my...
  • admin: How did you measure the 225mA output? Did you connect 4 diodes (regular rectifier diodes, not laser of course)...
  • David: Hello. I have extracted a 5.6mm diode from a 16x DL dvd burner, I already have an AiXiz module and driver...
  • admin: Thank you for stopping by, Mark! If you are using the same hardware, just be sure to not overload the driver...
  • Mark N: Spot on. exactly what I want. Just a fwd/Rev speed control, stepper motor to drive the X axis on my Milling...
  • admin: That’s right – R4 pulls the Enable input of the chip down, and the driver will be off until...
  • Nate: I have a question on the R3/R4 and ttl. So you say that if R4 is installed its normally off. So the laser is...
  • admin: Thanks for stopping by, Tom. I don’t have a ready-made DXF but the Eagle board file attached above in...
  • admin: It does need to be on a ferrous material for a great increase in performance. Although I do believe you can...
Meta